Chapter 19
| Spanning Tree Commands
– 534 –
Related Commands
spanning-tree mst port-priority (534)
spanning-tree
mst port-priority
This command configures the interface priority on a spanning instance in the
Multiple Spanning Tree. Use the no form to restore the default.
Syntax
spanning-tree mst instance-id port-priority priority
no spanning-tree mst instance-id port-priority
instance-id - Instance identifier of the spanning tree. (Range: 0-4094)
priority - Priority for an interface. (Range: 0-240 in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆ This command defines the priority for the use of an interface in the multiple
spanning-tree. If the path cost for all interfaces on a switch are the same, the
interface with the highest priority (that is, lowest value) will be configured as an
active link in the spanning tree.
◆ Where more than one interface is assigned the highest priority, the interface
with lowest numeric identifier will be enabled.
Example
Console(config)#interface Ethernet 1/5
Console(config-if)#spanning-tree mst 1 port-priority 0
Console(config-if)#
Related Commands
spanning-tree mst cost (533)
spanning-tree
port-bpdu-flooding
This command floods BPDUs to other ports when spanning tree is disabled globally
or disabled on a specific port. Use the no form to restore the default setting.
Syntax
[no] spanning-tree port-bpdu-flooding
Default Setting
Enabled
To Next Page
Loading...
