Chapter 19
| Spanning Tree Commands
– 525 –
Command Mode
MST Configuration
Command Usage
The MST region name and revision number (page 525) are used to designate a
unique MST region. A bridge (i.e., spanning-tree compliant device such as this
switch) can only belong to one MST region. And all bridges in the same region must
be configured with the same MST instances.
Example
Console(config-mstp)#name R&D
Console(config-mstp)#
Related Commands
revision (525)
revision This command configures the revision number for this multiple spanning tree
configuration of this switch. Use the no form to restore the default.
Syntax
revision number
number - Revision number of the spanning tree. (Range: 0-65535)
Default Setting
0
Command Mode
MST Configuration
Command Usage
The MST region name (page 524) and revision number are used to designate a
unique MST region. A bridge (i.e., spanning-tree compliant device such as this
switch) can only belong to one MST region. And all bridges in the same region must
be configured with the same MST instances.
Example
Console(config-mstp)#revision 1
Console(config-mstp)#
Related Commands
name (524)
To Next Page
Loading...
Need help?
General