Chapter 24
| Multicast Filtering Commands
MLD Filtering and Throttling
– 704 –
Example
Console(config)#ipv6 mld filter
Console(config)#
Related Commands
show ipv6 mld filter
ipv6 mld profile This command creates an MLD filter profile number and enters MLD profile
configuration mode. Use the no form to delete a profile number.
Syntax
[no] ipv6 mld profile profile-number
profile-number - An MLD filter profile number. (Range: 1-4294967295)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
A profile defines the multicast groups that a subscriber is permitted or denied to
join. The same profile can be applied to many interfaces, but only one profile can
be assigned to one interface. Each profile has only one access mode; either permit
or deny.
Example
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#
Related Commands
show ipv6 mld profile
permit, deny This command sets the access mode for an MLD filter profile. Use the no form to
delete a profile number.
Syntax
{permit | deny}
Default Setting
deny
To Next Page
Loading...
Need help?
General