Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 738 –
â—† The MVR6 group address range assigned to a profile cannot overlap with the
group address range of any other profile.
Example
The following example maps a range of MVR6 group addresses to a profile:
Console(config)#mvr6 profile rd ff01:0:0:0:0:0:0:fe ff01:0:0:0:0:0:0:ff
Console(config)#
mvr6
proxy-query-interval
This command configures the interval at which the receiver port sends out general
queries. Use the no form to restore the default setting.
Syntax
mvr proxy-query-interval interval
no mvr proxy-query-interval
interval - The interval at which the receiver port sends out general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Command Usage
This command sets the general query interval at which active receiver ports send
out general queries. This interval is only effective when proxy switching is enabled
with the mvr6 proxy-switching command.
Example
This example sets the proxy query interval for MVR6.
Console(config)#mvr proxy-query-interval 228
Console(config)#
mvr6 proxy-switching This command enables MVR proxy switching, where the source port acts as a host,
and the receiver port acts as an MVR router with querier service enabled. Use the
no form to disable this function.
Syntax
[no] mvr6 proxy-switching
To Next Page
Loading...
Need help?
General