Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 748 –
Command Mode
Privileged Exec
Example
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR Profile Name Start IPv6 Addr. End IPv6 Addr.
-------------------- ------------------------- -------------------------
rd ff01::fe ff01::ff
Console#
show mvr6 interface This command shows MVR configuration settings for interfaces attached to the
MVR VLAN.
Syntax
show mvr6 [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all attached interfaces.
Command Mode
Privileged Exec
Example
The following displays information about the interfaces attached to the MVR6
VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Leave Static Group Address
-------- -------- ------------------- ---------------- ---------------------
Eth1/ 1 Source Active/Forwarding
Eth1/ 2 Receiver Active/Forwarding Disabled ff00::1(VLAN2)
Console#
Table 144: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
To Next Page
Loading...
Need help?
General