Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 749 –
show mvr6 members This command shows information about the current number of entries in the
forwarding database, or detailed information about a specific multicast address.
Syntax
show mvr6 [domain domain-id] members [ip-address]
domain-id - An independent multicast domain. (Range: 1-5)
ip-address - IPv6 address for an MVR multicast group.
Default Setting
Displays configuration settings for all domains and all forwarding entries.
Command Mode
Privileged Exec
Example
The following shows information about the number of multicast forwarding entries
currently active in domain 1:
Console#show mvr6 domain 1 members
MVR6 Domain : 1
MVR6 Forwarding Entry Count :1
Flag: S - Source port, R - Receiver port.
H - Host counts (number of hosts join the group on this port).
P - Port counts (number of forwarding ports).
Up time: Group elapsed time (d:h:m:s).
Expire : Group remaining time (m:s).
Group Address VLAN Port Up time Expire Count
------------------------------ ---- ----------- ----------- ------ --------
ff05::101 2 00:00:00:19 2(P)
2 Eth1/ 2(S)
1 Eth1/ 4(R) 0(H)
Console#
Status Shows the MVR status and interface status. MVR status for source ports is
“ACTIVE” if MVR is globally enabled on the switch. MVR status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR groups, or a multicast group has been statically assigned to
an interface.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the receiver VLAN.
Table 144: show mvr6 interface - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General