Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 60 –
Reset Restarts the switch immediately, at a specified time, after a specified
delay, or at a periodic interval
113
Interface 117
Port 118
General 118
Configure by Port List Configures connection settings per port 118
Configure by Port Range Configures connection settings for a range of ports 120
Show Information Displays port connection status 121
Mirror 122
Add Sets the source and target ports for mirroring 122
Show Shows the configured mirror sessions 122
Statistics Shows Interface, Etherlike, and RMON port statistics 128
Chart Shows Interface, Etherlike, and RMON port statistics 128
Transceiver Shows identifying information and operational parameters for optical
transceivers which support Digital Diagnostic Monitoring (DDM), and
configures thresholds for alarm and warning messages for optical
transceivers which support DDM
133
134
Cable Test Performs cable diagnostics for selected port to diagnose any cable
faults (short, open etc.) and report the cable length
136
Trunk 138
Static 139
Configure Trunk 139
Add Creates a trunk, along with the first port member 139
Show Shows the configured trunk identifiers 139
Add Member Specifies ports to group into static trunks 139
Show Member Shows the port members for the selected trunk 139
Configure General 139
Configure Configures trunk connection settings 139
Show Information Displays trunk connection settings 139
Dynamic 142
Configure Aggregator Configures administration key and timeout for specific LACP
groups
142
Configure Aggregation Port 139
Configure 139
General Allows ports to dynamically join trunks 142
Actor Configures parameters for link aggregation group members on the
local side
142
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General