Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 61 –
Partner Configures parameters for link aggregation group members on the
remote side
142
Show Information 148
Counters Displays statistics for LACP protocol messages 148
Internal Displays configuration settings and operational state for the local side
of a link aggregation
149
Neighbors Displays configuration settings and operational state for the remote
side of a link aggregation
151
Configure Trunk 142
Configure Configures connection settings 142
Show Displays port connection status 142
Show Member Shows the active members in a trunk 142
Statistics Shows Interface, Etherlike, and RMON port statistics 128
Chart Shows Interface, Etherlike, and RMON port statistics 128
Load Balance Sets the load-distribution method among ports in aggregated links 152
Green Ethernet Adjusts the power provided to ports based on the length of the cable
used to connect to other devices
154
RSPAN Mirrors traffic from remote switches for analysis at a destination port on
the local switch
124
Traffic Segmentation 156
Configure Global Enables traffic segmentation globally 156
Configure Session Configures the uplink and down-link ports for a segmented group of
ports
157
VLAN Trunking Allows unknown VLAN groups to pass through the specified interface 159
VLAN Virtual LAN 163
Static
Add Creates VLAN groups 166
Show Displays configured VLAN groups 166
Modify Configures group name and administrative status 166
Edit Member by VLAN Specifies VLAN attributes per VLAN 169
Edit Member by Interface Specifies VLAN attributes per interface 169
Edit Member by Interface Range Specifies VLAN attributes per interface range 169
Dynamic
Configure General Enables GVRP VLAN registration protocol globally 173
Configure Interface Configures GVRP status and timers per interface 173
Show Dynamic VLAN 173
Show VLAN Shows the VLANs this switch has joined through GVRP 173
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General