How to Use This Guide
– 5 –
◆ Added the command "show process cpu task" on page 128.
◆ Added "Stacking" on page 195.
◆ Updated syntax for "snmp-server enable traps" on page 204.
◆ Added the commands "snmp-server enable port-traps mac-notification" on
page 208 and "show snmp-server enable port-traps" on page 208.
◆ Updated command usage section for the command "pppoe
intermediate-agent port-format-type" on page 296.
◆ Added the command "pppoe intermediate-agent port-format-type remote-id-
delimiter" on page 297.
◆ Added the command "mac-learning" on page 304.
◆ Updated command usage section for the command "port security" on
page 305.
◆ Added the command "port security mac-address-as-permanent" on page 307.
◆ Added the commands "ip dhcp snooping information option encode no-
subtype" on page 334, "ip dhcp snooping information option remote-id" on
page 335, and "ip dhcp snooping information option tr101 board-id" on
page 336.
◆ Added the commands "ipv6 dhcp snooping option remote-id" on page 346,
and "ipv6 dhcp snooping option remote-id policy" on page 347.
◆ Updated syntax for the command "ip source-guard binding" on page 353 and
"ip source-guard max-binding" on page 357, and "show ip source-guard
binding" on page 359.
◆ Added the commands "ip source-guard mode" on page 357 and "clear ip
source-guard binding blocked" on page 358.
◆ Updated syntax for the command "media-type" on page 419.
◆ Updated range for the commands "transceiver-threshold current" on page 432,
"transceiver-threshold rx-power" on page 433, "transceiver-threshold
temperature" on page 434, "transceiver-threshold tx-power" on page 435, and
"transceiver-threshold voltage" on page 436.
◆ Added the command "show interfaces transceiver-threshold" on page 438.
◆ Updated command usage section for the command "power inline maximum
allocation" on page 458.
To Next Page
Loading...
