How to Use This Guide
– 6 –
◆ Updated syntax for the command "auto-traffic-control control-release" on
page 485.
◆ Added the command "loopback-detection action" on page 492.
◆ Removed the command “loopback-detection mode.”
◆ Added the command "loopback detection trap" on page 494.
◆ Added the commands "udld detection-interval" on page 497, "udld recovery"
on page 499, and "udld recovery-interval" on page 499.
◆ Updated range for the command "mac-address-table aging-time" on page 505.
◆ Added the commands "spanning-tree tc-prop" on page 521, "spanning-tree
tc-prop-stop" on page 537, and "show spanning-tree tc-prop" on page 541.
◆ Updated syntax for the command "mac-vlan" on page 611.
◆ Updated syntax for the commands "show qos map cos-dscp" on page 631,
"show qos map dscp-mutation" on page 631, and "show qos map phb-queue"
on page 632.
◆ Added the commands "clear ip igmp snooping groups dynamic" on page 673,
and "clear ip igmp snooping statistics" on page 673.
◆ Updated command usage section for the command "ip igmp authentication"
on page 683.
◆ Added the commands "clear ipv6 mld snooping groups dynamic" on page 699
and "clear ipv6 mld snooping statistics" on page 700.
◆ Updated range for the command "mvr priority" on page 714.
◆ Added the commands "clear mrv groups dynamic" on page 723 and "clear mrv
statistics" on page 723.
◆ Updated syntax for the command "show mvr members" on page 727 and
"show mvr statistics" on page 729.
◆ Added the command "mvr6 priority" on page 736.
◆ Added the command "clear efm oam event-log" on page 850.
◆ Updated syntax for the commands "ip route" on page 958 and "show ip route"
on page 960.
◆ Added BGP to the parameter list for the RIP command "redistribute" on
page 973.
To Next Page
Loading...
Need help?
General