90
────────────────────────────────────────────────────
5.2 Making Settings
────────────────────────────────────────────────────
NOTE
Printing as numeric data
Method
1. Press the STATUS key to call up the
STATUS 1 screen.
2. Move the flashing cursor to the print mode
item, as shown in the figure on the left
3. Use the function keys to select numeric data.
: Waveform data are printed as a waveform.
: Waveform data are printed as numeric data.
4. Move the flashing cursor to the print interval
item.
5. Use the JOG control or the function keys to
select the print interval.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
・When the print interval longer than the recording length is set, only the
first dot is printed.
・The maximum and minimum values are printed (see Section Appendix 3.4).
・The print intervals of 0.01 to 0.5 DIV can be selected, only when there are
wavefom data present.
To Next Page
Loading...
