Hioki 8835-01 - Clear Waveform Data [ WAVE DATA CLEAR ]

240
────────────────────────────────────────────────────
9.7 Initialization [ INITIALIZE ]
────────────────────────────────────────────────────
9
.7.2 Clear Waveform Data [ WAVE DATA CLEAR ]
Method 2 Screen: SYSTEM 5 (INITIALIZE)
(For correcting errors of less than 1 minute)
1. Press the SYSTEM key to call up the
INITIALIZE screen.
2. Move the flashing cursor to any of the year,
month, day, hour, minute items of (1) TIME
SET, as shown in the figure on the left.
3. Press
F4 [30secadjust] to make the setting.
When F4 [30secadjust] is pressed, the seconds
are handled as follows.
00 - 29 seconds: Minutes are unchanged and
seconds are reset to 00.
30 - 59 seconds: Minutes are advanced by 1
and seconds are reset to 00.
Clears and initializes waveform data stored in memory.
Method Screen: SYSTEM 5 (INITIALIZE)
1. Press the SYSTEM key to call up the
INITIALIZE screen.
2. Move the flashing cursor to (2) WAVE DATA
CLEAR, as shown in the figure on the left,
and make the setting.
3. Press
F1 [exec].