Hioki 8835-01 - Setting Integral Measurement

146
────────────────────────────────────────────────────
7.7 Making the Settings of the 8940 F/V UNIT
────────────────────────────────────────────────────
NOTE
5V
-5 V
0V
Threshold
7
.7.3 Setting Integral Measurement
NOTE
Setting the Threshold Value
Set the threshold value.
Method Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Move the flashing cursor to the threshold
value item.
3. Use the function keys or the jog control to
make the setting.
: Value up, large step
: Value up, small step
: Value down, small step
: Value down, large step
Measurement results may differ depending on the threshold setting.
To obtain the correct measurement, set the threshold to match the input
waveform.
Threshold Setting Example
・Set integral measurement.
・Adds input pulse counts.
Setting the Measurement Mode
Method Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Move the flashing cursor to the unit item.
3. Use the
JOG control or the function keys to
select count.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
: Probe check is performed.
For the probe check, see Section 7.7.5.