Hioki 8835-01 - Character Entry Procedure

227
────────────────────────────────────────────────────
9.5 Adding Comments to a Graph [ COMMENT ]
────────────────────────────────────────────────────
9
.5.5 Character Entry Procedure
Indicates the copy source channe
l
The procedure for entering the characters for the comments, units, etc. is
described.
Method Screen: SYSTEM 3 (COMMENT)
1. Move the flashing cursor to the position in
which you want to enter the comment.
2. Use the function keys to make the selection.
: Enter a comment.
: Clear a comment.
3. Use the cursor keys to select the character,
and press the F1 (set) key to enter it.
・Use the
JOG control to move the cursor.
JOG control: Moves the cursor in the
character entry field
Cursor: Move the the character selection
cursor.
・The
VIEW key performs backspacing.
4. When the all the characters are entered,
press the
F5 (quit) key.
A comment made on one channel can be copied onto another channel. This
can be done for either an analog or logic channel.
Method
1. Move the flashing cursor to the channel for
which you want to enter the comment.
2. Use the function keys to select the channel
to be copied.
: Channel number up
: Channel number down
: Copy the comments for the selected
channel.