Hioki 8835-01 - Specifications; Chapter 14 Specifications; General Specifications Overview; Basic Specifications

283
────────────────────────────────────────────────────
13.3 Handling the PC Card
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
3.3.2 Using the PC Card Slot (PC Card with a Cable Only)
CAUTIO
N
When making the connection, the cable connector and PC card should be
properly aligned, so that the connector can be pushed in straight. Do not exert
strong force on the PC card connector, to prevent the possibility of damage
and contact problems.
Fig. 13.1 Passing protector through connection cable
Connection cabl
e
Front marking
s
PC car
d
PCMCIA socket sid
e
Loc
k
Locking sprin
g
Ｐrotecto
r
Fig. 13.2 Connection cable and PC card connection
Cable and PC card connection
1. Pass the PC card protector through the connection cable, as shown below.
2. Plug the PC card end of the connection cable into the PC card. The top side
of the cable connector (marked with a ▲) should match the top side of the
PC card, as shown below.