Hioki 8835-01 - Operation Sequence

100
────────────────────────────────────────────────────
6.1 Outline
────────────────────────────────────────────────────
6
.1.2 Operation Sequence
Turn on the powe
r.
Connect the inputs
.
Printed recording
Make trigger settings
.
Select the RMS recorder function.
Determine the speed with which the
input signal waveform is captured.
Set the frequency of the measuring object
.
Determine the length of the data sample
for a single measurement.
Select the format type for the waveform
display screen.
Select whether the result of waveform
calculation is printed as waveform or as
numeric data.
Select whether or not to enable additiona
l
recording.
Select whether or not to save the
waveform automatically after it is
captured.
Set the trigger source, trigger types and
conditions, the pre-trigger, etc.
Set the waveform display color for each
channel, voltage axis range, input
coupling, zero position, and filter.
The waveform display position for each
channel can be set to any position.
Press the
START key to start
measurement.
After the data capture, print the result.
Set the time axis rang
e
(TIME/DIV).
Set the recording length
.
Select function
.
Select the forma
t.
Channel 1 scree
n
Channel 2 scree
n
Start
Status 1 screen
Status 2 screen
Measurement
End
Set the voltage axis range
,
input coupling, etc.
Set the variable function
.
Start measuremen
t.
Select the printer forma
t.
Set the additional recordin
g
function.
Make printer settings
.
Set the frequency
.
Set auto save function
.
The flowchart below illustrates the sequence of operations involved in using
the RMS recorder function.