Hioki 8835-01 - Trigger Timing in Recorder Function

153
────────────────────────────────────────────────────
7.8 Making the Settings of the 8946 4 ch ANALOG UNIT
────────────────────────────────────────────────────
7
.8.2 Setting the Input Coupling
The input coupling for the input signal is set.
Method Screen: CHANNEL 1, DISPLAY
1. Call up the CHANNEL 1 or DISPLAY screen.
2. Use the
CH SELECT key to open selected
channel screen.
3. Move the flashing cursor to the point shown
in the figure on the left.
4. Use the function keys to make the selection.
: DC coupling
: The input signal is not connected.
This allows the zero position to be checked.