Hioki 8835-01 - Processing Method

69
────────────────────────────────────────────────────
4.4 Processing Functions (Waveform Parameter Processing)
────────────────────────────────────────────────────
4
.4.2 Processing Method
NOTE
Settings for the processing method are made with the status 3 screen.
Method Screen: STATUS 3
1. Call up the STATUS 3 screen.
2. Move the flashing cursor to the point shown
in the figure on the left.
3. Use the function keys to make the selection.
: Parameter processing is disabled.
: Parameter processing is enabled.
: Processing is performed for the already
captured waveform. Processing can be
stopped with the STOP
key.
When parameter processing is disabled, the
other setting items are not displayed at all.
4. If parameter processing is set to ON, the
various setting items are displayed.
5. Move the flashing cursor to the point shown
in the figure on the left, and enable or
disable printout of parameter processing
results. Use the function keys to make the
selection
: Processing results are not printed.
: Processing results are printed.