70
────────────────────────────────────────────────────
4.4 Processing Functions (Waveform Parameter Processing)
────────────────────────────────────────────────────
NOTE
6. Move the flashing cursor to the point shown
in the figure on the left, and enable or disable
storing of parameter processing results. Use
the function keys to make the selection.
: Processing results are not stored.
: Processing results are stored on floppy disk.
: Processing results are stored on PC card.
・Processing results are stored as text data.
・A file is stored in the directory currently
selected on the file screen.
・The LAN selection is available only when a
LAN is connected.
7. Select processing functions and set the
channel for processing. Four processing
functions can be performed simultaneously.
(1) Move the flashing cursor to the point shown
in the figure.
Use the function keys to select processing
functions.
(2) Move the flashing cursor to the point shown
in the figure, and set the channel.
Use the function keys to make the selection.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
To Next Page
Loading...
