0.7.3 Real-Time Print (Recorder, RMS Recorder)
NOTE
Range Compression ratio
50 ms/DIV × 1/2
20 ms/DIV × 1/10
10 ms/DIV × 1/20
The input waveform and data are printed continuously in real time.
Method Screen: STATUS 1
1. Call up the STATUS screen 1.
2. Move the flashing cursor to the printer item,
as shown in the figure on the left.
3. Use the function keys to make the selection.
: Disable real-time print print
: Enable real-time print print
4. When measurement starts, waveform
appears on screen and print starts.
・At a time axis range setting of 200 ms/DIV or faster, the waveform data will
be printed out later.
・While the printer always outputs the data at the measurement
magnification in recording mode, the waveform on the screen is reduced in
size at the ratio shown in the table below, depending on the time-axis range.
・When time axis range is between 10 ms - 200 ms/DIV and recording length
is set to CONTINUOUS in recorder function, printer defaults to OFF.
・If the A/B cursors are used, partical save isn’t applied.
To Next Page
Loading...
