Hioki 8835-01 - Setting the Beep Sound; Setting the Language

209
────────────────────────────────────────────────────
9.3 Special Function Settings [ SETUP ]
────────────────────────────────────────────────────
9
.3.10 Setting the Beep Sound
9
.3.11 Setting the Language
Serves to set the beep sound.
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET UP
screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Use the function keys to make the selection.
: Beep is not heard.
: Beeps at error, warning, and failure of
measuring waveform area decision (advanced
version) and waveform parameter decision
(advanced version).
: Beeps at start, trigger, stop, completion of
automatic save, error, warning, and failure
of measuring waveform area decision
(advanced version) and waveform parameter
decision (advanced version).
Serves to set the display language.
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Use the function keys to make the selection.
: The display language is Japanese.
: The display language is English.