.6.5 Setting the LAN Interface
■ LAN Interface
The 8835-01 MEMORY HiCORDERs provide the LAN functions below by
using a LAN card inserted in the PC card slot.
Supporting the 9333
When using the HIOKI 9333 LAN COMMUNICATOR, you can remotely
control the 8835-01 on a PC or use the Auto Save function to save 8835-01
data on a PC via the 9333. For details, refer to the instruction manual
provided with the 9333.
Communications Command
The 8835-01 can be operated using common RS-232C/GPIB communications
commands. The 8802 port is set as the command input port by default. To
control the 8835-01, create a program and connect TCP via this port. For
details, see the Application Disk (CD-R.)
■ Compatible LAN Card
The LAN cards below are compatible with the 8835-01. (As of April 2003)
HIOKI 9578 10BASE-T LAN CARD *
KOREGA FEther II PCC-TXD
For the latest information, visit the HIOKI website.
*: Sales of the HIOKI 9578 10BASE-T LAN CARD have been discontinued.
Please use the commercially available LAN cards recommended by HIOKI.
■ Setting
This section describes the setting procedure.
Set up the 8835-01 and connect the cable in the sequence below.
1. Insert a LAN card.
2. Set up the LAN parameters in "SYSTEM 4." (Do not connect the cable yet.)
For details, see "Setting Individual Parameters" below.
3. After setting all the parameters, press F5 [Enter].
4. Connect the LAN cable to the 8835-01 and the network.
Be sure to make the settings above before connecting the 8835-01 to the
network. Note that making these settings with the 8835-01 connected to the
network may result in illegal information being sent to the network-for
example, if the same IP address as that of another device on the network is
selected.
To Next Page
Loading...
