234
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
4. Stop bit
Set the stop bit. Move the flashing cursor to
the position shown in the figure on the left,
and use the function keys to make the
selection.
: Set to 1 bit.
: Set to 2 bits.
5. Delimiter
Set the delimiter. Move the flashing cursor to
the position shown in the figure on the left,
and use the function keys to make the
selection.
: Set to LF.
: Set to CR+LF.
6. Header
Set the header. Move the flashing cursor to
the position shown in the figure on the left,
and use the function keys to make the
selection.
: Header information is not appended.
: Header information is appended.
7. Flow control
Set the flow control. Move the flashing cursor
to the position shown in the figure on the left,
and use the function keys to make the
selection.
: None
: Software handshake
: Hardware handshake
To Next Page
Loading...
