Hioki 8835-01 - Setting the Zero Position

124
────────────────────────────────────────────────────
7.3 Making the Settings of the 8936 ANALOG UNIT
────────────────────────────────────────────────────
7
.3.6 Setting the Zero Position
On the DISPLAY screen, flashing cursor at zer
o
indicates zero position.
NOTE
NOTE
The position of the zero voltage is set.
Method 1 Screen: CHANNEL 1, DISPLAY
1. Call up the CHANNEL 1 or DISPLAY screen.
2. Use the
CH SELECT key to open selected
channel screen.
3. Move the flashing cursor to the point shown
in the figure on the left.
4. Use the JOG control or the function keys to
make the selection.
: Changes the +10% zero position.
: Changes the +1% zero position.
: Changes the -1% zero position.
: Changes the -10% zero position.
On the DISPLAY screen, the setting cannot be
made with the
JOG control.
Method 2 Screen: CHANNEL 1, DISPLAY
1. Call up the CHANNEL 1 or DISPLAY screen.
2. Use the
CH SELECT key to open selected channel screen.
3. Press the front-panel
POSITION key for the channel whose zero position
you want to adjust.
・The
POSITION key can be used regardless of where the flashing cursor is
located, if the selected channel is displayed on the CHANNEL 1 or
DISPLAY screen.
・Magnification/compression along the voltage axis is performed using the
center of the screen as reference,