.6 Interface Settings (Media Settings)
・Settings for various interfaces
・The output destination for the
COPY key can be set (see Section 9.6.1).
・The output destination for the
PRINT key can be set (see Section 9.6.2).
・GP-IB settings can be performed when the 9558 GP-IB CARD is installed
(see Section 9.6.3).
・RS-232C card settings can be performed when the 9557 RS-232C CARD is
installed (see Section 9.6.4).
・LAN settings can be performed when the 9578 10BASE-T LAN CARD is
installed. High-speed data transfer between the 8835-01 and a PC, and
remote control from a PC, can be performed over the LAN when the 9578
10BASE-T LAN CARD and the 9333 LAN COMMUNICATOR software are
installed. (see Section 9.6.5)
Please refer to the 9578 10BASE-T LAN CARD and 9333 LAN
COMMUNICATOR Instruction Manual for details.
A BMP file name can be entered when the COPY key output destination is set to
floppy disk, PC card or interface.
Method Screen: SYSTEM 4 (INTERFACE)
1. Move the flashing cursor to the BMP file name
item, as shown in the figure on the left.
2. Enter the BMP file name. Default name is
"IMAGE."
For details on the procedure for entering the
characters, see Section 9.5.5.
To Next Page
Loading...
