Hioki 8835-01 - Window-In, Window-Out Trigger

160
────────────────────────────────────────────────────
7.10 Making Logic Input Settings
────────────────────────────────────────────────────
Position
1
2
3
4
5
6
7
8
Logic waveform
display position
7
.10 Making Logic Input Settings
・Select the display positions for CH A - CH D (1 probe).
・Select the display color for the logic waveform.
Method Screen: CHANNEL 1
1. Press the CHAN key to call up the
CHANNEL 1 screen.
2. Set the display position.
(1) Move the flashing cursor to the "Position"
point of the channel to be set, as shown in
the figure on the left.
(2) Use the function keys to set the position.
: Change the display position.
: Change the display position.
: Logic waveforms are not displayed.
: All logic waveforms are displayed.
: Set to the displayed position number.
The logic waveform display positions are as
follows.
3. Set the display color.
(1) Move the flashing cursor to the "1, 2, 3, 4"
item of the channel for which the display
color is to be set, as shown in the figure on
the left.
(2) Use the
JOG control or the function keys to
make the selection.