Hioki 8835-01 - Input Channel Settings; Chapter 7 Input Channel Settings; Selecting Channels for Memory Recorder

95
────────────────────────────────────────────────────
5.3 Settings on the Display Screen
────────────────────────────────────────────────────
5
.3.1 Setting Compression Along the Time Axis
NOTE
Range Compression ratio
50 ms/DIV × 1/2
20 ms/DIV × 1/10
10 ms/DIV × 1/20
5
.3 Settings on the Display Screen
Explains the setting items on the Display screen.
・The compression ratio along the time axis can be set.
・By compressing the waveform, an entire change can be promptly apprehended.
Method 6-19
1. Move the flashing cursor to the position
shown in the figure on the left.
2. Use the function keys to select the
compression ratio.
: Ratio up
: Ratio down
・The compression factor can be changed also after measurement is
completed.
・While the printer always outputs the data at the measurement
magnification in recording mode, the waveform on the screen is reduced in
size at the ratio shown in the table below, depending on the time-axis range.
Reference The VIEW key can be used to check which position within the entire
recording length is occupied by the currently shown waveform (see Section
3.1.7).