Hioki 8835-01 - Trigger Timing (Recorder Function)

175
────────────────────────────────────────────────────
8.4 Trigger Timing (Recorder Function)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
8
.4 Trigger Timing (Recorder Function)
・The moment the trigger occurs, the time related to the waveform being
recorded can be set.
・Not only the waveform after the trigger but also the waveform before the
trigger can be recorded.
Method Screen: STATUS 2
1. Call up the STATUS 2 screen.
2. Move the flashing cursor to the timing item,
as shown in the figure on the left.
3. Use the function keys to make the selection.
: Recording starts when the trigger is
applied.
: Recording starts only when the START
key is pressed, and stops when the trigger
is applied.
: Recording starts when the trigger is
applied, and stops when the trigger is
applied next.