Hioki 8835-01 - Setting the Grid; Channel Marker Function

205
────────────────────────────────────────────────────
9.3 Special Function Settings [ SETUP ]
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
9
.3.3 Setting the Grid
9
.3.4 Channel Marker Function
NOTE
・Selects the type of grid shown on the display screen and drawn on the
recording paper.
・The following five settings are available: OFF, standard, fine, standard (dark),
fine (dark).
・On the waveform display screen, the standard and fine grids are defined as
the standard, and the standard (dark) and fine (dark) grids are defined as the
standard (dark) grids.
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Press the function key to make the setting.
: No grid on display and printout
: Standard grid on printout
: Fine grid on printout
: Standard (dark) grid on printout
: Fine (dark) grid on printout
The channel numbers or the comments are printed together with the
waveform on the recording paper (see Section 9.5).
Method Screen: SYSTEM 1 (SET UP) 11-10
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Press the function key to make the selection.
: Channel numbers will not be printed for the
waveform on the recording paper.
: Channel numbers will be printed for the
waveform on the recording paper.
: Comments will be printed for the waveform
on the recording paper.
This function cannot be used in FFT function (advanced version).