Hioki 8835-01 - GP-IB Interface Settings

232
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
9
.6.3 GP-IB Interface Settings
NOTE
When the GP-IB interface has been selected,
and the 9558 GP-IB CARD is connected, the
following items must be set.
・Settings are not displayed unless the 9558
GP-IB CARD is connected.
・For more details, refer to its instruction
manual.
1. Mode
Set the mode. Move the flashing cursor to the
position shown in the figure on the left, and
use the function keys to make the selection.
: ADDRESSABLE
: TALK ONLY
: DISABLE
2. Address
Set the address. Move the flashing cursor to
the position shown in the figure on the left,
and use the
JOG control or the function keys
to make the setting.
(0 to 30)
: Address up
: Address down
3. Header
Set the header. Move the flashing cursor to
the position shown in the figure on the left,
and use the function keys to make the
selection.
: Header information is not appended.
: Header information is appended.