Hioki 8835-01 - Self Check Procedures

220
────────────────────────────────────────────────────
9.4 Scaling Function [ SCALING ]
────────────────────────────────────────────────────
9
.4.4 Copy Settings
Specifies the copy
destination channe
l
Specifies copy
source channe
l
Scaling settings can be copied from one channel to another, by specifying
either a conversion ratio or two points.
Method Screen: SYSTEM 2 (SCALING)
1. Move the flashing cursor to the channel
number of the copy destination channel.
2. Use the function keys or the Jog/Shuttle
control to specify the copy target channel.
Selection of "for ALL" enables the settings
(comments) for the channel with the flashing
cursor to be copied to all channels
: Select next higher channel.
: Copy source channel.
: Select next lower channel.
:Execute.
3. Press the Execute function key to copy.
In the example at the left, CH1 settings are
copied to CH2.