Hioki 8835-01 - Zoom Function

265
────────────────────────────────────────────────────
11.4 Zoom Function
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Magnified rang
e
Standard scree
n
Z
oom scree
n
1
1.4 Zoom Function
(Memory Waveform Only in the Memory Recorder Function and
the Recorder and Memory Function*)
This function divides the display screen into two screens (upper and lower),
and allows the waveform on the upper screen to be magnified along the time
axis and displayed on the lower screen.
In the recorder and memory function*, the following operations are required.
1. Capture the waveform in the recorder and memory function.
2. Change the function to the memory recorder function.
3. The memory waveform is continuously relayed.
4. Zooming affects this waveform.
*: Advanced version
Method Screen: DISPLAY
1. Press the DISP key to call up the DISPLAY
screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Use the function keys to select zoom.
: Time axis direction magnification up
: Time axis direction magnification down
: Zoom function is used.
When the zoom function is selected, the
display is split into two horizontally tiled
screens.
The waveform before the zoom mode was
activated is displayed on the upper screen
(standard screen). The lower screen shows
the zoomed waveform (zoom screen).
4. Use the
JOG control or the function keys to
set the magnification ratio.
The lower screen’s display magnification is
always larger than the upper screen’s display
magnification.
〔〕brackets on the upper screen indicate the
waveform range displayed on the lower
screen.