Hioki 8835-01 - Input Level Monitor Function

166
────────────────────────────────────────────────────
7.13 Input Level Monitor Function
────────────────────────────────────────────────────
NOTE
Channel
1
Channel
2
Channel
3
Channel
4
L
ogic CHA to CHD
Waveform leve
l
Full spa
n
Waveform levels on channels
1 to 8 are displayed from the lef
t.
Dual screen
Single screen
Indicates that the input waveform is outside the display range
.
Indicates the instantaneous value
of each channel.
(The instantaneous value is update
d
approximately every 500 ms.)
Channel
5
Channel
6
Channel
7
Channel
8
7
.13 Input Level Monitor Function
・It is possible to set the voltage axis range and zero position while monitoring
the levels of the all the input waveforms in real time.
・The display is for each of channels 1 to 8 and logic channel groups A to D.
・Only numerical values are displayed during measurement (while the LED above
the
START key is lit). A bar graph is also displayed while waiting for trigger.
Method Screen: Display
1. Press the VIEW key.
2. Use the function keys to select level monitor.
3. Use the
INPUT RANGE key and the
POSITION key to change the voltage axis
range and zero position respectively.
The level monitor is not displayed for the
disabled channel.