Hioki 8835-01 - Manual Trigger Operation

178
────────────────────────────────────────────────────
8.6 Using the Analog Trigger Function
────────────────────────────────────────────────────
8
.6.1 Level Trigger (RMS Recorder Function Excluded)
T
rigger leve
l
T
rigger leve
l
U
pward trigger direction (slope :
)
D
ownward trigger direction (slope :
)
I
nput waveform
Method
1. Move the flashing cursor to the point shown
in the figure on the left.
2. Use the function keys to select the channel
for which you want to set the analog trigger.
: Channel number up
: Channel number down
・Triggering occurs when the input signal crosses the preset trigger level
(voltage) with the preset trigger slope (
, ).
・When a trigger filter is used, triggering occurs only within the filter width.
This is useful to exclude noise.