Hioki 8835-01 - Printing Procedure; Manual Print (All Functions)

252
────────────────────────────────────────────────────
10.7 Printing Procedure
────────────────────────────────────────────────────
1
0.7.1 Manual Print (All Functions)
NOTE
Gaug
e
Lis
t
1
0.7 Printing Procedure
The following printing modes are available:
・Manual print (
PRINT key, DISPLAY screen)
・Auto print (set with STATUS screen)
・Real-time print (set with STATUS screen)
・Partial print (A/B cursors,
PRINT key, DISPLAY screen)
・Screen hard copy (
COPY key)
・List print (
PRINT key, any screen except DISPLAY screen)
・Report print (
FEED key + COPY key, DISPLAY screen)
・External printer (print by the external printer)
This mode serves to print waveform data from the internal memory.
Memory recorder:
Measurement data from one measurement (entire recording length) are
printed.
Recorder:
Measurement data stored in memory before the end of measurement are
printed (2000 divisions max.).
RMS Recorder:
Measurement data stored in memory before the end of measurement are
printed (2000 divisions max.).
Method Screen: DISPLAY
After the measurement is completed, press the PRINT key.
・Since data are stored, they can be printed as often as desired.
・When magnification/compression was used, the print reflects this condition.
Information about settings and scale can also be printed at the same time (see
Section 9.3.6).
Both the list and gauge functions are used.