Hioki 8835-01 - RS-232 C Interface Settings

233
────────────────────────────────────────────────────
9.6 Interface Settings (Media Settings)
────────────────────────────────────────────────────
9
.6.4 RS-232C Interface Settings
NOTE
When the RS-232C interface has been
selected, and the 9557 RS-232C CARD is
connected, the following items must be set.
・Settings are not displayed unless the 9557
RS-232C CARD is connected.
・For more details, refer to its instruction
manual.
1. Transfer rate
Set the transfer rate. Move the flashing cursor
to the position shown in the figure on the left,
and use the function keys to make the
selection.
2. Data word length
Set the data word length. Move the flashing
cursor to the position shown in the figure on
the left, and use the function keys to make the
selection.
: Set the data word length to 8 bits.
: Set the data word length to 7 bits.
3. Parity
Set the parity. Move the flashing cursor to the
position shown in the figure on the left, and
use the function keys to make the selection.
: No parity
: Even parity
: Odd parity