0.7.4 Partial Print (All Functions)
NOTE
This function prints the waveform between the A and B cursors (vertical or trace
cursors).
・Memory recorder
Specified range (out of entire data recorded from a measurement) is printed.
・Recorder, RMS Recorder
Specified range (out of last 2000 divisions (magnification: ×1) of data in
memory) is printed.
The function is available also when the A/B cursors are currently outside the
range displayed on screen.
For details regarding the use of the A/B cursors, refer to Section 11.2.
Printing is possible also when the print format is currently set to "numeric".
Method Screen: DISPLAY
1. Position cursor A at the start point of the
range to be printed.
2. Move cursor B to the right. When the cursor
is at the rightmost edge of the screen, the
waveform scrolls to the left, and cursor A
scrolls with it.
3. Specify the end point of the range with
cursor B. Then press the
PRINT key. The
specified range is printed, also if cursor A is
currently off screen.
・The range is printed also if the positions of cursor A and cursor B are
reversed.
・When only the cursor A is used, the waveform data from the position of
cursor A to the end of the data is printed.
To Next Page
Loading...
