.2.10 Input Channel Settings
6. Use the function keys to select the data store
principle.
: Data are stored as binary data.
: Data are stored as text data.
・Data stored in the text format is not readable
by the 8835-01.
・When the characters below are used in a file,
the file cannot be handled on a PC running
Windows 2000 or XP. Do not use these
characters when handling a file on your PC.
+, =, [, ]
7. Selected TEXT in save options opens
Thinning.
Use the
JOG control or the function keys to
make the selection.
・In automatic save channels cannot be selected. Only current channel
displaying waveform is saved.
・A file is stored in the directory currently selected on the file screen.
・Only a limited number of directories and files can be stored in the directory.
・When the recording length is "continuous", the auto save function is
disabled.
・When the auto save function is used while the additional recording function
is ON, only newly acquired waveform data is stored. (In this case, the A/B
cursors are set OFF.)
・X-Y combined waveforms cannot be stored automatically.
・If the data quantity is too large, it may not fit on a floppy diskette or PC
Card. For the size of a file, see Section Appendix 4.
Select the trigger that is suitable for the signal to be captured.
For details, see Chapter 8.
The settings differ for each unit.
See the settings for each unit in Chapter 7.
To Next Page
Loading...
