.2.2 Setting the Time Axis Range
NOTE
NOTE
・Set the speed for inputting and storing the waveform of the input signal.
・Time axis range setting expresses the time for 1 DIV.
・The sampling interval is constant, regardless of the time axis range.
Method 1 Screen: STATUS 1, DISPLAY
1. Call up the STATUS 1 or DISPLAY screen.
2. Move the flashing cursor to the time/div item,
as shown in the figure on the left.
3. Use the
JOG control or the function keys to
make the selection.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
On the DISPLAY screen, the selection window
is not displayed.
07-04
07-05
Method 2 Screen: STATUS 1, DISPLAY
1. Call up the STATUS 1 or DISPLAY screen.
2. Use the
TIME/DIV key to make the selection.
The
TIME/DIV key can be used regardless of where the flashing cursor is
located, if the STATUS 1 or DISPLAY screen is displayed.
To Next Page
Loading...
