Hioki 8835-01 - Setting the Magnification;Compression Ratio Along the Voltage Axis

123
────────────────────────────────────────────────────
7.3 Making the Settings of the 8936 ANALOG UNIT
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
7
.3.5 Setting the Magnification/Compression Ratio Along the
Voltage Axis
NOTE
・Specifies the magnification/compression ratio for each channel to be used for
display and recording.
・Performs magnification/compression using the center of the screen as
reference.
Method 1 Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Use the
CH SELECT key to open selected
channel screen.
3. Move the flashing cursor to the point shown
in the figure on the left.
4. Use the function keys to make the selection.
: Display is compressed to 1/2.
: Display is shown as is.
: Display is magnified by factor 2.
: Display is magnified by factor 5.
: Display is magnified by factor 10.
Magnification/compression is performed using the center of the screen as
reference, if the magnification /compression ratio is changed.
Method 2 Screen: DISPLAY
1. Call up the DISPLAY screen.
2. Use the
CH SELECT key to open selected
channel screen.
3. Move the flashing cursor to the point shown
in the figure on the left.
4. Use the function keys to make the selection.
: Ratio up
: Ratio down