.6.1 Setting the Output Destination by the COPY Key
NOTE
NOTE
The screen data output destination when the COPY key is pressed is
specified.
Method Screen: SYSTEM 4 (INTERFACE)
: Output to internal printer.
: Output to external printer.
: Output to floppy disk (BMP format).
: Output to PC card (BMP format).
: Output using the interface (BMP format).
The 9559 PRINTER CARD is required to print
on an external printer (see Section 10.7.8).
When the external printer is the output destination, select the control code.
: Uses ESC/P as the control code.
: Uses ESC/P raster as the control code.
Select the printing size (external printer only).
: Print normal size.
: Print at 1.5 times magnification.
When the internal printer is not the output destination, select the color of the
output destination.
: Output color data.
: Output gray-scale data.
: Output monochrome data.
: Output reverse monochrome data.
・When the output destination specified excluding internal and external
printer and the color is set to monochrome, the screen is displayed in
monochrome while data saving is in progress.
・Stores a file in the directory currently selected on the file screen.
・Refer to printer manual for control code selections.
・A file stored in the BMP format is not readable by the 8835-01.
・When the LAN interface is selected, only Color and Monochrome output
destination color selections are available.
To Next Page
Loading...
