Hioki 8835-01 - Setting for Measuring Frequency

142
────────────────────────────────────────────────────
7.7 Making the Settings of the 8940 F/V UNIT
────────────────────────────────────────────────────
7
.7.2 Setting for Measuring Frequency
NOTE
Measurement of frequency allows three types of measurements: frequency,
cycle and commercial power supply.
Frequency is between 0.1 Hz to 10 kHz, cycle is between 10 r/min to 1 kr/min
and commercial power supply is P50 Hz or P60 Hz.
Setting the Measurement Mode
Method Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Move the flashing cursor to the unit item.
3. Use the
JOG control or the function keys to
select Frequency.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
: Probe check is performed.
For the probe check, see Section 7.7.5.