0.5 Channel Marker Function
・Selects the type of grid shown on the display screen and drawn on the
recording paper.
・The following five settings are available: OFF, standard, fine, standard (dark),
fine (dark).
・The display on the display screen is as follows:
Standard, fine: standard
Standard (dark), fine (dark): standard (dark)
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Press the function key to make the setting.
: No grid on display and printout
: Standard grid on printout
: Fine grid on printout
: Standard (dark) grid on printout
: Fine (dark) grid on printout
The channel numbers or comments are printed together with the waveform on
the recording paper.
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Press the function key to make the selection.
: Channel numbers will not be printed for the
waveform on the recording paper.
: Channel numbers will be printed for the
waveform on the recording paper.
: Comments set for each channel will be
printed for the waveform on the recording
paper (refer to Section 9.5).
To Next Page
Loading...
