Hioki 8835-01 - Using the Timer Trigger Function

196
────────────────────────────────────────────────────
8.8 Using the Timer Trigger Function
────────────────────────────────────────────────────
T
ime interv
al
S
tart tim
e
S
top tim
e
T
ime interv
al
8
.8 Using the Timer Trigger Function
・This function serves to activate recording at preset times.
・Triggering can be performed at constant intervals within a preset start time
and stop time.
The internal trigger (analog trigger etc.) can be made active for the preset
time interval only.
→ Set the time interval to 0.
Method Screen: STATUS 2
(1) Set the timer trigger
1. Press the
STATUS key to call up the
STATUS 2 screen.
2. Move the flashing cursor to the timer source
item, as shown in the figure on the left.
3. Use the function keys to select ON.
(2) Set the start and end time
1. Move the flashing cursor to the start item.
2. Use the function keys or the
JOG control to
make the setting.
: Value up, 10-units
: Value up, 1-units
: Value down, small step
: Value down, 10-units
: Use current time as start time or end time.
3. Move the flashing cursor to the stop item.
4. Use the function keys or the
JOG control to
make the setting.