197
────────────────────────────────────────────────────
8.8 Using the Timer Trigger Function
────────────────────────────────────────────────────
NOTE
(3) Set the trigger interval (day, hour, minute, second)
1. Move the flashing cursor to the interval item,
as shown in the figure on the left.
2. Use the function keys or the
JOG control to
make the setting.
Available time ranges are between 0 day 0
hour 0 minute 0 second to 31 days 23 hours
59 minutes 59 seconds.
・Set the start time and end time to a point after the pressing of the
START
key.
・When the trigger mode is set to "Single", only one trigger event is valid for
the start time. The settings for time interval and end time are invalid (when
timer trigger only is ON).
・When trigger sources have been linked with OR, all trigger sources that are
ON are valid. Therefore triggering may occur even before the start time, and
trigger standby and measurement may continue even after the stop time.
・When trigger sources have been linked with AND, trigger standby is
enabled at the measurement start time and at each time interval, and
triggering will occur when all trigger conditions other than timer trigger are
met simultaneously.
・To perform recording at regular intervals, establish the following settings.
Trigger mode: continuous
Trigger source linking: AND or OR
Other trigger sources: all OFF
Between end of recording and standby, triggers are invalid while processing
is taking place (auto save, auto print, waveform display process, calculation
process) and therefore data may not be recorded at regular intervals with
some measurement setting.
To Next Page
Loading...
