.2.7 Setting the Printer Function (Real Time Printing)
NOTE
Method
1. Press the STATUS key to call up the
STATUS 1 screen.
2. Move the flashing cursor to the additional
recording item, as shown in the figure on the
left
3. Use the function keys to make the selection.
: Additional recording is disabled.
: Additional recording is enabled.
・Time values output to the printer and displayed on the screen with the
additional recording function enabled are equal to those of the most recently
acquired waveforms. Therefore, when measuring waveforms in a different
time axis range, always take that difference into consideration.
・The voltage axis range is determined by the most recently acquired
waveforms.
The input waveform is continuously printed in real time.
Method
1. Press the STATUS key to call up the
STATUS 1 screen.
2. Move the flashing cursor to the printer item,
as shown in the figure on the left
3. Use the function keys to make the selection.
: Printing is disabled.
: Printing is enabled.
See Section 10.7.3.
To Next Page
Loading...
