287
────────────────────────────────────────────────────
13.4 Storing, Retrieving and Deleting Data on the Floppy Disk or PC Card
────────────────────────────────────────────────────
Color setting Size of a file
color, gray-scale 308,278 bytes
monochrome, reverse monochrome 38,462 bytes
NOTE
3.4.4 Selecting the Media Type
(2) Measurement data (WAVE)
1. It is possible to save the measurement data of a waveform which has been
captured.
2. When measurement data is read into the 8835-01, the waveform data
recorded on the floppy disk or PC card is put into the designated memory
channel.
3. When the measurement data of a waveform is recorded, its setting state
(the recording length, time axis, voltage axis, scaling and comments) is also
simultaneously recorded. Because when this is loaded the unit is set to the
condition when the measurement data was recorded, it can be checked by
being listed. (see "File contents" in Section 13.4.5.) (Logic channels CHA to
CHD are considered as one channel in any function.) For the size of a file,
see Section Appendix 5.
(
3) Screen hard copy (BMP)
The each screen display of the 8835-01 can be stored in the bit map file (BMP)
format.
Size of a file
・The bit map file is one of the standard graphic type of the WINDOWS*,
therefore by using the graphic software, this file format can be used.
・For setting the output destination of the screen display data, see Section
9.6.1.
*: The WINDOWS is a registered trademark of Microsoft Corporation.
・The number of bytes depends on the floppy disk or PC CARD format.
・Data stored in the BMP format is not readable by the 8835-01.
・If the A/B cursors are used, partical save is applied (see Section 13.4).
The media type is specified.
1. Press the
FILE key to call up the FILE
screen.
2. Move the flashing cursor to the position
shown in the figure on the left, and use the
function keys to make the selection.
: Floppy disk media are used.
: PC card media are used.
To Next Page
Loading...
