Hioki 8835-01 - Setting Pre-trigger for Recorders

150
────────────────────────────────────────────────────
7.7 Making the Settings of the 8940 F/V UNIT
────────────────────────────────────────────────────
7
.7.6 Setting for Measuring Current
・Measures electric current with clamp on sensor or clamp on probe.
・When starting up MEMORY HiCORDER with 9439 DC POWER ADAPTER,
measuring in parallel with printing this limits number of available channels
for current measurement.
・The settings of the waveform display color, waveform display graph type,
input coupling, magnification/compression ratio along the voltage axis, zero
adjustment, baseline offset and low-pass filter are the same as in the 8936
ANALOG UNIT. For the settings, see Section 7.3.
Setting the Measurement Mode
Method Screen: CHANNEL 1
1. Call up the CHANNEL 1 screen.
2. Move the flashing cursor to the unit item.
3. Use the
JOG control or the function keys to
select Current.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.