Hioki 8835-01 - Settings on the Display Screen

66
────────────────────────────────────────────────────
4.3 Settings on the Display Screen
────────────────────────────────────────────────────
4
.3.1 Setting Magnification/Compression Along the Time Axis
NOTE
4
.3 Settings on the Display Screen
Explains the setting items on the Display screen and the setting of the voltage
axis and time axis.
・The magnification/compression ratio along the time axis can be set.
・By magnifying the waveform, detailed observations can be made. By
compressing the waveform, an entire change can be promptly apprehended.
・Magnification/compression of the screen uses the left edge as reference,
regardless of the status of the A/B cursor.
Method -19
1. Move the flashing cursor to the position
shown in the figure on the left.
2. Use the function keys to select the
magnification/compression ratio.
: Ratio up
: Ratio down
The magnification/compression factor can be changed also after measurement
is completed.
Reference
・The HELP key can be used to check which position within the entire
recording length is occupied by the currently shown waveform (see
VIEW key
in Section 3.1.7).
・It is possible to divide the display screen into two screens (upper and lower),
and magnify the waveform on the upper screen along the time axis and
display it on the lower screen (see Section 11.4).