207
────────────────────────────────────────────────────
9.3 Special Function Settings [ SETUP ]
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
.3.8 Setting Backlight Saver Function
・Serves to set the printer density.
・The density can be set in five steps.
・Select the setting which yields the most easy to read printout.
Method Screen: SYSTEM 1 (SET UP) 11-12
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Use the function keys to make the selection.
: Print light
: Print semi-light
: Print standard density
: Print semi-dark
: Print dark
・When this function is enabled, LCD backlighting is turned off automatically if
no key is pressed for the preset interval.
・Pressing any key will turn the display on again.
・This increases the service life of the backlight.
Method Screen: SYSTEM 1 (SET UP)
1. Press the SYSTEM key to call up the SET
UP screen.
2. Move the flashing cursor to the position
shown in the figure on the left.
3. Use the function keys to make the selection.
: Increase time.
: Decrease time.
: Disable the backlight saver function.
OFF: The display is shown continuously.
1 to 30: The display automatically goes off
after the preset interval (minutes).
To Next Page
Loading...
